Archive for the ‘Testing’ Category
Snetterton 300
Thursday, November 17th, 2011Testing at Silverstone
Monday, September 6th, 2010With the car effectively being a new one after all the updates/changes etc, we were out at Silverstone on Friday in preparation for the upcoming LMS event this week. In fact we took both cars for the day as both Richard and I are racing.
The car ran well and the temperature inside the cabin was MUCH improved. The aero updates also made a big improvement. Unfortunately I lost half the day as a front wheel bearing failed after three laps. We managed to find a replacement and get it fitted for the afternoon though. The car then ran round and apart from a slight issue with the downshift, it turns out the throttle cable has slightly settled meaning the blip didnt operate the butterflies, the car ran well.
I didnt puch too hard as I had never driven the circuit and have not exactly really driven the car! that and all the changed meant I was cautious and after a few laps would come in to get the team to check it over before going out for some more laps.
Mainly though it was an absolute blast and I am now really excited about this weekend. I am not expecting too much result wise, but a finish I think would be a real result after all the hard work and effort.
2nd Outing
Sunday, February 14th, 2010Well, I have been out for a second time. Unfortunately I dont have any photos as they were really on the case stopping you!
Anyway, in short, the modifications were all successful. The upright flex is now non existent, or at least you dont know about it. I may still make some new uprights, but at least now its not critical! The cooling was very much improved, which is a bonus!
The car onlya ran round for half a day, as in the afternoon I took and passed my ARDS test! So, hopefully I will get my license later this week, assuming I have filled it all in right!
Not sure when I will be out again, perhaps middle of March. Things are really busy at the moment, and I want to do some more changes/mods! To this end I have taken the engine out to look at the generator, as the charging circuit still doesnt work. I should have more on this next week! There is also a possible new sump pan to try.






