I was somewhat dreading plumbing up the fuel filling pipes. Only because I could see it was going to be very fiddly and take an inordinate amount of time! The first job was to make some ally T pieces. These were just made of 2 inch ally tube, although I had noticed that 2 inch pipe and samco all seemed to be about the same size, whereas what was sold as 2 inch necks on the filler plate appeared to be more like 2.5 inch! Anyway, the samco stretched enough so it wasnt really a problem, just very awkward!

  (more…)

As I have two fuel tanks, although often a good idea anyway, I have decided to use a fuel collector. The one I have made is approx 1 litre capacity, which should give plenty of running without picking anything out of the main tank. I have used #4 pipe from the main tanks to this, and for the return both from the engine and to the tanks to try to keep down the weight. Below is the position of the collector, at the rear of the car on the drivers side.

(more…)